Trimmed the rudder to fit the bottom. Normally you wouldn't have to do that but because the Star 47.5 RC sailboat hull is flatter than the regular Star 45 RC sailboat, I needed to do it. Then covered it in fiberglass and squeegeed it off.
Then cut out a piece of 1/16" plywood to make the bulkhead that will later be glued to the aft side of frame 6. After several test fits I then clear coated the aft side of it. Will glue it in later this week I think.
I'm not really sure yet where I'm going with the cockpit area and will just have to figure it out as I go. It'll be fine!
Aloha! _/)
Then cut out a piece of 1/16" plywood to make the bulkhead that will later be glued to the aft side of frame 6. After several test fits I then clear coated the aft side of it. Will glue it in later this week I think.
I'm not really sure yet where I'm going with the cockpit area and will just have to figure it out as I go. It'll be fine!
Aloha! _/)
Comments
Post a Comment
Please feel free to leave comments regarding building a Star 45.